Universal Aluminum Bumper Vent Size:18" x 4.5" On IS300/IS200 version - (4)

On IS300/IS200 version - (4) 3/8" holes must be drilled in the pinch weld for the lower side of the mounting plates to be attached

otherwise the filter cover will match the tank color

ESTIMATED BUILD TIME: 1-2 weeks

25x25mm bolts

* This bar is not intended for street use - off-road use only *

Universal Aluminum Bumper Vent Size:18" x 4.5" On IS300/IS200 version - (4)Bumper vent panels are a great addition to cars with a rear diffuser or half cut rear bumper. These allow for air to pass through your bumper without getting trapped. FEATURES: Laser cut from . 063" aluminum Includes 1 8" aluminum rivets Includes inner sandwich ring to prevent rivets from pulling through plastic bumper TOOLS REQUIRED FOR INSTALLATION: Drill 1 8" drill bit Rivet install tool (1 8" rivets) Dremel or angle grinder with cutoff wheel Tape